SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2020SOUL LX, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLABS/ESC DIAGNOSISDTC C2380-01: ABS/TCS/ESP VALVE ERRORCOMPONENT INSPECTION
2020 Kia Soul LX, Standard Trans

Component Inspection

2020 Kia Soul LX, Standard TransSECTION Component Inspection
Inspection Condition Inspection Procedure Reference
  1. Ignition "ON".
  1. Connect KDS to "Data Link connector (DLC)".
  2. Perform "Actuation Test" and monitor parameter in "Current Data" with KDS.
 Fig.1 to 8
G13285849Courtesy of KIA MOTORS AMERICA, INC.
G13285850Courtesy of KIA MOTORS AMERICA, INC.
G13285851Courtesy of KIA MOTORS AMERICA, INC.
G13285852Courtesy of KIA MOTORS AMERICA, INC.
G13285853Courtesy of KIA MOTORS AMERICA, INC.
G13285854Courtesy of KIA MOTORS AMERICA, INC.
G13285855Courtesy of KIA MOTORS AMERICA, INC.
G13285856Courtesy of KIA MOTORS AMERICA, INC.

Good 

  • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
  • Repair or replace as necessary and then go to "Verification of Repair " procedure.

No Good 

  • Carefully re-do this troubleshooting guide steps.
  • If no problems were found with the circuits or connectors, replace the ESC and go to "Verification of Repair " procedure.

    * In case of replacing ESC, perform "Vehicle S/W Management" procedure as COMPONENT INSPECTION  of C110101.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.