Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Battery Inspection
2015 Kia Soul EV BaseSECTION Battery Inspection
- Measure voltage between the battery terminal(+) and the battery terminal(-).
Specification:
- IG ON: Approx. 12V
- EV Mode (Drive Mode): Approx. 14V
- Is the measured value within specifications~
YES
- Go to "IGNITION CIRCUIT INSPECTION " procedure.
NO
- Check that the fuse, terminal of battery, all terminals of LDC are in good condition and Check for damaged harness and poor connection between LDC and battery.
- If OK, check DTCs in LDC system. If there is a code related to vehicle, Repair according to DTC diagnostic guide of LDC system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.