Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Circuit Inspection
2015 Kia Soul EV BaseSECTION Power Circuit Inspection
- IG "ON".
- Measure voltage between Pin No. 2 (power) terminal of WSS (RL) harness connector and chassis ground.
Specification: Approx 12V (Connected)
- Is the measured value within specifications?
YES
- Go to "SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair as necessary and go to "Verification Of Vehicle Repair " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.