SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - 2.7LDTC P0481: FAN 2 CONTROL CIRCUITINSPECTION/REPAIRW/HARNESS INSPECTIONPOWER SUPPLY CIRCUIT INSPECTION
2010 Kia Rondo LX, 2.7 6

Power Supply Circuit Inspection

2010 Kia Rondo LX, 2.7 6SECTION Power Supply Circuit Inspection
  1. Check voltage
    1. IG "OFF".
    2. Disconnect the Radiator fan relay (High).
    3. IG "ON" and ENG "OFF"
    4. Measure the voltage between terminal 30, 85 of the Radiator fan relay (High) harness connector and chassis ground.
      1. Specification: B+
        Fig 1: Measuring Voltage Between Terminal 30, 85 Of Radiator Fan Relay (High) Harness Connector & Chassis Ground
        G06489292Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the measured voltage within specification?

      YES

      1. Go to "CONTROL CIRCUIT INSPECTION " procedure.

      NO

      1. Check if Radiator fan fuse is open or not installed.
      2. Repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.