SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - 2.7LDTC P0463: FUEL LEVEL SENSOR A CIRCUIT HIGH INPUTGENERAL INFORMATIONDTC DETECTING CONDITION
2010 Kia Rondo LX, 2.7 6

General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Detects a continuous short to battery in either the signal circuit or the fuel level sender
  • Poor Connection
  • Short to battery in signal Circuit
  • Faulty Fuel Level sender
  • Faulty PCM
Enable Conditions
  • Engine Running
  
Threshold value
  • Raw fuel level sender output > 10.8V
Diagnosis Time
  • -
MIL On Condition
  • 2 driving cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.