SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - 2.7LDTC P0444: EVAP. EMISSION SYSTEM - PURGE CTRL. VALVE CIRCUIT OPENINSPECTION/REPAIRCOMPONENT INSPECTION
2010 Kia Rondo LX, 2.7 6

Component Inspection

2010 Kia Rondo LX, 2.7 6SECTION Component Inspection
  1. Check PCSV
    1. IG "OFF" and disconnect PCSV connector.
    2. Measure resistance between terminals 1 and 2 of PCSV connector. (Component side)
      1. Specification:
        COIL RESISTANCE SPECIFICATION CHART

        Item Coil resistance(Ξ©)
        PCSV 14.0 ~ 18.0Ξ© (at 20Β°C/68Β°F)
        Fig 1: Measuring Resistance Between Terminals 1 & 2 Of PCSV Connector
        G06489213Courtesy of KIA MOTORS AMERICA, INC.
    3. Is the measured resistance within specification?

      YES

      • Substitute with a known-good PCM and check for proper operation.
      • If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIRΒ " procedure.

      NO

      • Substitute with a known-good PCSV and check for proper operation.
      • If the problem is corrected, replace PCSV and go to "VERIFICATION OF VEHICLE REPAIRΒ " procedure.
        CAUTION: There is a memory reset function on the scantool that can erase optional components automatically detected and memorized by the PCM. Before or after testing PCM on the vehicle, use this function to reuse the PCM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.