Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024WAGONEER L SERIES II, RWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE SYSTEM CONTROL MODULE (BSCM) - DTCS B1783-00 TO C0057-00
2024 Jeep Wagoneer L Series II, RWD
Brake System Control Module (BSCM) - DTCS B1783-00 To C0057-00
2024 Jeep Wagoneer L Series II, RWDSECTION Brake System Control Module (BSCM) - DTCS B1783-00 To C0057-00
- DTC Troubleshooting
- B1783-00 Stop Lamp Control
- C0001-00 TCS Control Channel A Valve 1
- C0002-00 TCS Control Channel A Valve 2
- C0003-00 TCS Control Channel B Valve 1
- C0004-00 TCS Control Channel B Valve 2
- C0010-00 Left Front Inlet Control
- C0011-00 Left Front Outlet Control
- C0014-00 Right Front Inlet Control
- C0015-00 Right Front Outlet Control
- C0018-00 Left Rear Inlet Control
- C0019-00 Left Rear Outlet Control
- C001C-00 Right Rear Inlet Control
- C001D-00 Right Rear Outlet Control
- C0021-00 Brake Booster
- C0024-00 Brake Pedal Feedback Pressure Solenoid Circuit
- C003F-00 Wheel Speed Sensors Rotation Direction Correlation
- C0049-00 Brake Fluid Level
- C0050-00 Brake System Hydraulic Leak
- C0051-00 Steering Wheel Position Sensor
- C0056-00 Left Front Wheel Speed Sensor Direction
- C0057-00 Right Front Wheel Speed Sensor Direction
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.