Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE L LAREDO, AWDREPAIR AND DIAGNOSISRESTRAINTSSEAT BELTSOCCUPANT RESTRAINT CONTROLLER (ORC) - DTCS B00B5-95 TO B1CFE-11DTC TROUBLESHOOTINGB00DF-95-PASSENGER RESTRAINTS DISABLE SWITCH-INCORRECT ASSEMBLYDIAGNOSTIC TEST
2023 Jeep Grand Cherokee L Laredo, AWD
Diagnostic Test
2023 Jeep Grand Cherokee L Laredo, AWDSECTION Diagnostic Test
- CHECK FOR AN ACTIVE DTC
- With the scan tool, read ORC DTCs and record on the repair order.
- Record the Environmental Data.
- With the scan tool, erase DTCs.
- Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read ORC DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
- Probing of the circuit cavities at the ORC Module body harness connectors or vehicle connectors is only to be done with a approved test lead from the test lead 10159-6 or the use of Breakout Box 8443-55 to prevent vehicle wiring harness connector damage during diagnostic procedures.
- VERIFY THAT B00DF-95-PASSENGER RESTRAINT DISABLE SWITCH- INCORRECT ASSEMBLY - INCORRECT ASSEMBLY IS ACTIVE
- With the scan tool, erase ORC DTCs.
- Turn the ignition off, wait 10 seconds and then turn the ignition on.
- Wait 2 minutes, and then with the scan tool, read ORC DTCs.
Does the scan tool display active: B00DF-95-PASSENGER RESTRAINT DISABLE SWITCH- INCORRECT ASSEMBLY?
Yes
- Go To 3
No
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
- VERIFY WIRING
- Turn the ignition off.
- Inspect the instrument panel harness for switch wiring and/or switch and insure the module is correct for the vehicle application.
Are wiring or switch present?
Yes
- Insure correct ORC is installed and programmed correctly. Reprogram ORC if necessary.
No
- Replace the ORC in accordance with the Service Information. Refer to CONTROLLER, OCCUPANT RESTRAINT (ORC), REMOVAL AND INSTALLATION .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.