Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE L LAREDO, AWDREPAIR AND DIAGNOSISRESTRAINTSSEAT BELTSOCCUPANT RESTRAINT CONTROLLER (ORC) - DTCS B00B5-95 TO B1CFE-11
2023 Jeep Grand Cherokee L Laredo, AWD
Occupant Restraint Controller (Orc) - DTCS B00B5-95 To B1CFE-11
2023 Jeep Grand Cherokee L Laredo, AWDSECTION Occupant Restraint Controller (Orc) - DTCS B00B5-95 To B1CFE-11
- DTC Troubleshooting
- B00B5-95-Driver Seat Track Position Restraints Sensor-Incorrect Assembly
- B00B5-9A-Driver Seat Track Position Restraints Sensor-Component Or System Operating Conditions
- B00C5-11-Passenger Seat Track Position Restraints Sensor-Circuit Short To Ground
- B00C5-12-Passenger Seat Track Position Restraints Sensor-Circuit Short To Battery
- B00C5-13-Passenger Seat Track Position Restraints Sensor-Circuit Open
- B00C5-95-Passenger Seat Track Position Restraints Sensor-Incorrect Assembly
- B00C5-9A-Passenger Seat Track Position Restraints Sensor-Component Or System Operating Conditions
- B00DF-95-Passenger Restraints Disable Switch-Incorrect Assembly
- B0099-96-Roll Over Sensor-Component Internal Failure
- B12C7-51-Original TVV - Not Programmed
- B12C8-00-Original TVV - Not Locked
- B1A40-00-Authentication Counter Out Of Sync-
- B1A4A-00-Authentication Key Negotiation Timeout-
- B1A4B-00-Authentication KEYSTORE Full-
- B1A4C-00-Excessive Authentication Messages Detected-
- B1A4D-00-Default Authentication Key - Negotiation Required-
- B1BA5-00-Airbag Squib Configuration Mismatch-
- B1BAA-00-Occupant Classification Module Configuration Mismatch
- B1BB9-00-Airbag Squib Circuit Coupling
- B1BC7-00-Deployment Data Record Full
- B1BD3-00-Non Regular Operation Flag
- B1BD5-00-Yaw Non Regular Operation Flag
- B1CFE-11-First Row Center Airbag Squib-Circuit Short To Ground
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.