Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2013WRANGLER SPORT, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 146 ((PARK ASSIST MODULE (PAM) (PTS/PAM) - ELECTRICAL DIAGNOSTICS))DTC TROUBLESHOOTINGU0418-00-IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM CONTROL MODULEDIAGNOSTIC TEST
2013 Jeep Wrangler Sport, Automatic Trans
Diagnostic Test
2013 Jeep Wrangler Sport, Automatic TransSECTION Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
- Turn the ignition on.
- With the scan tool, read Park Assist Module DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- VERIFY ABS IS ACTIVE ON THE CAN BUS
- With the scan tool, select ECU View.
- Verify that the ABS is active on the bus.
Is the ABS active on the bus?
Yes
- Go To 3
No
- Refer to DIAGNOSIS AND TESTING and perform the No Response from ABS diagnostic procedure.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- DTCS STORED OR ACTIVE IN THE ANTILOCK BRAKE MODULE (ABS)
- With the scan tool, read ABS DTCs.
Are any DTCs active or stored in the ABS?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
No
- Go To 4
- With the scan tool, read ABS DTCs.
- ACTIVE COMMUNICATION DTCS IN THE BCM
- With the scan tool, select ECU View and select BCM.
- With the scan tool, read active DTCs.
Are any Communication DTCs active in the BCM?
Yes
- Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
No
- Replace and program the Park Assist Module in accordance with the Service Information. Refer to MODULE, PARK ASSIST, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.