Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2007PATRIOT LIMITED, FWD, STANDARDREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSDTCS B1B8E TO B1C2BB1BBD-OCM CURRENT CONFIGURATION TABLE UNPROGRAMMEDDIAGNOSTIC TEST
2007 Jeep Patriot Limited, FWD, Standard
Diagnostic Test
2007 Jeep Patriot Limited, FWD, StandardSECTION Diagnostic Test
- 1) MODULE CONFIGURATION
Does the scan tool display B1BBD-OCM CURRENT CONFIGURATION TABLE UNPROGRAMMED?
Yes
- Perform the B1BA7-OCCUPANT CLASSIFICATION SYSTEM VERIFICATION REQUIRED diagnostic procedure.
No
WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.- Replace the OCM in accordance with the service information.
- With the scan tool, perform *OCM SYSTEM VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.