Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 210 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE

2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Steering Wheel Control Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Position the steering wheel control switch to the steering wheel.
Connect the electrical connector to the steering wheel control switch.
Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.

Fig 2: View Of Shroud & Screws

Courtesy of GENERAL MOTORS CORP.

Install the shroud to the steering wheel.

NOTE: Refer to Fastener Notice .

Install the shroud retaining screws to the steering wheel.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the steering wheel. Refer to Steering Wheel Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.