SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 210 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)COMPONENT LOCATORSECONDARY/CONFIGURABLE CONTROL CONNECTORSSTEERING WHEEL CONTROL SWITCH ASSEMBLY - LOWER LEFT (STW)
2006 Isuzu Ascender S, 5.3 M, 4WD

Steering Wheel Control Switch Assembly - Lower Left (STW)

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Steering Wheel Control Switch Assembly - Lower Left (STW)
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel Control Switch Assembly - Lower Left (STW) Connector End View
GM605502Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly - Lower Left (STW) Connector Parts Information

Connector Part Information 
  • OEM: 50-57-9404
  • Service: Service by Harness - See Part Catalog
  • Description: 4-Way F (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
Steering Wheel Control Switch Assembly - Lower Left (STW) Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 BN 230 Instrument Panel Lamps Dimming Control
2 YE 1327 DIC Fuel Signal
3 D-BU 894 DIC Toggle Switch Signal
4 BK 2250 Ground
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.