SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMIRRORSSTATIONARY WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
    IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  1. Open the hood.
    2. CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  2. Cover and protect the following parts from broken glass:
    • Upper dash pad
    • Defroster outlets and A/C outlets
    • Seats and carpeting
  3. Remove the fixed antenna mast, if equipped. Refer to Fixed Antenna Mast Replacement in Entertainment.
  4. Remove the windshield wiper arms. Refer to Wiper Arm Replacement (GMC Envoy) or Wiper Arm Replacement (SS) in Wipers/Washer Systems.
  5. Remove the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Envoy, TrailBlazer) or Air Inlet Grille Panel Replacement (Rainier) in Body Front End.
    6. Fig 1: Removing/Installing Weather-Strip Retainers
    GM588275Courtesy of GENERAL MOTORS CORP.
  6. Remove the push-pins (2) from the front door sealing weatherstrips (1) located at the base of the pillar.
    7. Fig 2: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  7. Reposition the front door sealing weatherstrips (1) in order to access the side reveal molding screws.

    It is not necessary to remove the front door sealing weatherstrip completely from the vehicle.

    8. Fig 3: Removing Window Side Reveal Molding Screws
    GM398502Courtesy of GENERAL MOTORS CORP.
  8. Remove the side reveal moldings screws.
    9. Fig 4: Removing Reveal Molding
    GM398501Courtesy of GENERAL MOTORS CORP.
  9. Remove the side of the reveal moldings.
  10. Remove the rearview mirror. Refer to Rearview Mirror Replacement .
  11. Remove the rain sensor, if equipped. Refer to Windshield Outside Moisture Sensor Replacement in Wipers/Washer Systems.
    12. Fig 5: Identifying Upper Reveal Molding from Windshield
    GM105242Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.