SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMREPAIR INSTRUCTIONSWIPER ARM REPLACEMENT (SS)
2006 Isuzu Ascender S, 5.3 M, 4WD

Wiper Arm Replacement (SS)

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Wiper Arm Replacement (SS)
Fig 1: Wiper Arm Replacement
GM1649374Courtesy of GENERAL MOTORS CORP.
Wiper Arm Replacement (SS)

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
1 Windshield Washer Arm Finish Cover
Tip:  Use a small flat-bladed tool to remove finish cap.
2 Windshield Washer Arm Nut
Tip:  Hold wiper arm blade tip to the target marks in the lower blackout area of the windshield while tightening the nut.

Tighten:  35 N.m (26 lb ft).
3 Windshield Washer Arm
Tip:  Use a J 39637  or slightly rock the arm on the wiper pivot shaft to remove.
4 Windshield Wiper Arm Blade
Tip:  Pinch the wiper blade tabs and rotate the blade away from the arm and gently push outward in order to remove the blade from the arm.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.