Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Moisture Sensing Feature Inoperative
2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Moisture Sensing Feature Inoperative
Moisture Sensing Feature Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Wiper/Washer System Schematics Connector End View Reference: Wiper/Washer System Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Verify the fault is present. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | While the windshield wiper/washer system is in the automatic mode does the wiper motor operate at continuous delay intervals? | Go to Step 5 | Go to Step 4 |
| 4 |
|
Go to Step 5 | Go to Wipers Inoperative - One or More Modes |
| 5 |
|
Go to Step 6 | Go to Step 8 |
| 6 | Connect a test lamp from the accessory voltage supply circuit terminal to the ground circuit terminal in the moisture sensor harness connector. Does the test lamp illuminate? |
Go to Step 7 | Go to Step 9 |
| 7 | Test the moisture sensor signal 1 circuit for an open, short to ground, or short to voltage. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 10 |
| 8 | Repair the accessory voltage supply circuit to the moisture sensor for an open or short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Is the repair complete? |
Go to Step 12 | - |
| 9 | Repair the moisture sensor ground circuit for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Is the repair complete? |
Go to Step 12 | - |
| 10 | Inspect for poor connections at the moisture sensor. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 11 |
| 11 | Replace the moisture sensor. Refer to Windshield Outside Moisture Sensor Replacement . Did you complete the replacement? |
Go to Step 12 | - |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.