Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Activating SRS System
Turn ignition switch to "LOCK" and remove the key. Connect Yellow 4-way connector passenger-side air bag module. Install glovebox. Connect Yellow 3-way connector at the base of steering column. Install SRS fuse C-21, C-22, C-23 and C-24 to left dash side lower fuse block or reconnect battery. Turn ignition switch to "ON" and verify that "AIR BAG" warning lamp flashes seven times and then turns off. If it does not operate as described, see DIAGNOSTIC PROCEDURES .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.