Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Terminals and Reference Value for BCM
2006 Infiniti FX35 AWDSECTION Terminals and Reference Value for BCM
BCM CONNECTOR TERMINAL VOLTAGE SPECIFICATIONS
| Terminal | Wire color | Item | Signal Input/output | Condition | Voltage (V) (Approx.) |
|---|---|---|---|---|---|
| 11 | LG | ACC power supply (ACC or ON) | Input | Ignition switch (ACC or ON position) | Battery voltage |
| 12 | P/B | Front door switch passenger side signal | Input | ON (Open) --> OFF (Closed) | 0 --> Battery voltage |
| 13 | P/L | Rear door (RH) switch signal | Input | ON (Open) --> OFF (Closed) | 0 --> Battery voltage |
| 18 | B | Remote keyless entry receiver (Ground) | - | - | 0 |
| 19 | R | Remote keyless entry receiver (Power supply) | Output | - | |
| 20 | Y | Remote keyless entry receiver (Signal) | Input | Stand-by | |
| When remote keyless entry receiver receives signal from keyfob. | |||||
| 22 | OR | Power window serial link | Input/Output | IGN SW ON or power window timer operating | |
| 23 | G/OR | Security indicator lamp | Output | Goes off --> Illuminates | Battery voltage --> 0 |
| 39 | L | CAN-H | Input/Output | - | - |
| 40 | P | CAN-L | Input/Output | - | - |
| 42 | L/R | Power source (Fuse) | Input | - | Battery voltage |
| 49 | B | Ground (signal) | - | - | 0 |
| 52 | B | Ground (power) | - | - | 0 |
| 55 | G | Power source (Fusible link) | Input | - | Battery voltage |
| 58 | L | Back door switch signal | Input | ON (Open) --> OFF (Closed) | 0 --> 9 |
| 62 | W | Front door switch driver side signal | Input | ON (Open) --> OFF (Closed) | 0 --> Battery voltage |
| 63 | P | Rear door (LH) switch signal | Input | ON (Open) --> OFF (Closed) | 0 --> Battery voltage |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.