Check ACC Switch

2006 Infiniti FX35 AWDSECTION Check ACC Switch
  1. CHECK ACC SWITCH 

    With CONSULT-II 

    Check ACC switch ("ACC ON SW") in "DATA MONITOR" mode with CONSULT-II.

    MONITOR ITEM CONDITION

    Monitor item Condition
    ACC SW Ignition switch position is ACC or ON : ON
    Ignition switch position is OFF : OFF
    Fig 1: CONSULT-II DISPLAY - "ACC ON SW"
    G04076972Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    Check voltage between BCM connector and ground.

    CONNECTOR TERMINAL VOLTAGE SPECIFICATIONS

    Item (+) (-) Condition Voltage (V) Approx.
    Connector Terminal (Wire color)
    BCM M3 11 (LG) Ground ACC or ON Battery voltage
    OFF 0
    Fig 2: Identifying Voltage Between BCM Connector And Ground
    G04076973Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK : ACC switch is OK.

    NG : Check the following.

    • 10A fuse [No. 6, located in fuse block (J/B)]
    • Harness for open or short between BCM and fuse.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.