CONSULT-II Function (BCM): Notes

2006 Infiniti FX35 AWDSECTION Notes

CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.

INSPECTION ITEMS DESCRIPTION

BCM diagnosis position Inspection items and diagnosis mode Description
BCM C/U(1) Self-diagnosis results Carries out the self-diagnosis.
DATA MONITOR Displays the input data to BCM on real-time basis.
CAN DIAG SUPPORT MNTR Displays CAN communication system diagnosis, disabled transmission status, and communication status of each unit communicated with BCM.
MULTI REMOTE ENT DATA MONITOR Displays the input remote keyless entry system data to BCM on real--time basis.
ACTIVE TEST Gives a drive to a load to check the operation.
WORK SUPPORT Changes the setting for each function.
(1) Refer to "PRECAUTIONS WHEN USING CONSULT-II ".
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.