Check Door Request Switch

With CONSULT-II 

Display "DR REQ SW" (driver door)"AS REQ SW" (passenger door) and "BD/TR REQ SW" (back door) on DATA MONITOR screen, and check if ON-OFF display is linked to door request switch operation.

Press door request switch. : ON 

Release door request switch. : OFF 

OK or NG 

OK : Door request switch is OK.

NG : GO TO 2.

Fig 1: CONSULT-II DISPLAY - "DR REQ SW"

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition knob LOCK position.
2. Disconnect door request switch connector.
3. Check voltage between door request switch connector D12 (driver door), D42 (passenger door), D113 (back door) terminal 1 and ground.

   Driver 1 (SB) - Ground : Approx. 5V 

   Passenger 1 (GY) - Ground : Approx. 5V 

   Back door 1 (GY) - Ground : Approx. 5V 

   Fig 2: Identifying Voltage Between Door Request Switch Connector D12, D113 Terminal 1 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK : GO TO 3.

NG : GO TO  5.

Check continuity between door request switch D12 (driver door), D42 (passenger door), D113 (back door) terminals 1 and 2.

OK or NG 

OK : GO TO 4.

NG : Replace door request switch.

Fig 3: Identifying Continuity Between Door Request Switch D12 (Driver Door), D42 (Passenger Door), D113 (Back Door) Terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.

Check continuity between door request switch connector D12 (driver side), D42 (passenger side), D113 (back door) terminal 2 (B) and ground.

2 (B) - Ground : Continuity should exist. 

OK or NG 

OK : Check harness connection.

NG : Repair or replace door request switch ground circuit.

Fig 4: Identifying Door Request Switch Ground Circuit

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect Intelligent Key unit connector.
2. Check continuity between Intelligent Key unit connector M34 terminals 5 (driver door), 25 (passenger door), and 29 (back door) and door request switch connector D12 (driver door), D42 (passenger door), D113 (back door) terminal 1.

   Driver 5 (W/L) - 1 (SB) : Continuity should exist. 

   Passenger 25 (W/R) - 1 (GY) : Continuity should exist. 

   Back door 29 (GY) - 1 (GY) : Continuity should exist. 

3. Check continuity between door request switch connector D12 (driver door), D42 (passenger door), D113 (back door) terminal 1 and ground.

   1 - Ground : Continuity should not exist. 

   Fig 5: Identifying Door Request Switch Circuit

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK : Replace Intelligent Key unit.

NG : Repair or replace harness between Intelligent Key unit and door request switch.