SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2022SANTA CRUZ SEL, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS - 2.5L (2 OF 16)DTC P0106-29: MANIFOLD ABSOLUTE PRESSURE/BAROMETRIC PRESSURE CIRCUIT RANGE/PERFORMANCEDTC INFORMATION AND INSPECTIONDTC DETECTING CONDITION
2022 Hyundai Santa Cruz SEL, FWD

DTC Information and Inspection: DTC Detecting Condition

2022 Hyundai Santa Cruz SEL, FWDSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Plausibility check
  1. Poor connector connection
  2. Air cleaner dirt
  3. Damage to the engine oil cap or dipstick, not attached or improperly mounted
  4. Intake system leakage
  5. Faulty MAPS circuit
  6. Faulty MAPS
Enable Condition
  • Ignition "ON"
  • Engine "OFF"
  • Battery voltage is between 11V and 16V
  • Pressure up throttle (PUT) sensor voltage is between 0.2V and 4.8V
Threshold Value
  • Difference between the intake manifold pressure and atmospheric pressure is more than 10 kPa when the engine is stopped
Diagnostic Time
  • 2 seconds
MIL ON Condition
  • 2 driving cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.