SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2022SANTA CRUZ SEL, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS - 2.5L (2 OF 16)DTC P00B7-94: ENGINE COOLANT FLOW LOW/PERFORMANCEDTC INFORMATION AND INSPECTIONDTC DETECTING CONDITION
2022 Hyundai Santa Cruz SEL, FWD

DTC Information and Inspection: DTC Detecting Condition

2022 Hyundai Santa Cruz SEL, FWDSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy Case1
  • Signal error - Learning time
  1. Poor connector connection
  2. Faulty ITM control circuit
  3. Faulty ITM
Case2
  • Signal error - Lower limit learning
Case3
  • Signal error - Upper limit learning
Case4
  • Actual position difference monitoring
Enable Condition Case1
  • Rotary coolant valve lower limit learning operation
  • Rotary coolant valve upper limit learning operation
Case2
  • Rotary coolant valve lower limit learning operation
Case3
  • Rotary coolant valve upper limit learning operation
Case4
  • Ignition "ON"
  • Completed learning the rotary coolant valve
Threshold Value Case1
  • Rotary coolant valve learning time more than 10 seconds
Case2
  • Rotary coolant valve lower limit position is between 23 and 38.5°
Case3
  • Rotary coolant valve upper limit position is between 353 and 369°
Case4
  • Difference between the ITM predicted position and actual position is above than 25 to 50°
Diagnostic Time Case1, 2, 3
  • 0.01 seconds
Case4
  • 1 second
MIL ON Condition
  • 2 driving cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.