Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER RE:FLEXREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLELECTRONIC STABILITY CONTROL (ESC) SYSTEM
2014 Hyundai Veloster RE:FLEX
Electronic Stability Control (ESC) System
2014 Hyundai Veloster RE:FLEXSECTION Electronic Stability Control (ESC) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- Failure Diagnosis
- Notes
- Memory of Fail Code
- Failure Checkup
- Countermeasures In Fail
- Warning Lamp ON
- Standard Flow Of Diagnostic Troubleshooting
- Notes With Regard To Diagnosis
- ABS Check Sheet
- Problem Symptoms Table
- ABS Does Not Operate
- ABS Does Not Operate (Intermittently)
- Communication with GDS is not possible
- Communication With GDS Is Not Possible
- When Ignition Key Is Turned ON (engine OFF), The ABS Warning Lamp Does Not Light Up
- Even After The Engine Is Started, The ABS Warning Lamp Remains ON
- Failure Diagnosis
- Bleeding Of Brake System
- EBD (Electronic Brake-Force Distribution)
- ESC Control Module
- Front Wheel Speed Sensor
- Rear Wheel Speed Sensor
- Yaw-Rate And Lateral G Sensor
- ESC OFF Switch
- Steering Angle Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.