SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEM/ELECTRONIC STABILITY CONTROL SYSTEM DIAGNOSISDTC C1282: YAW RATE & LATERAL G SENSOR-ELECTRICALGENERAL INFORMATIONDTC DETECTING CONDITION
2014 Hyundai Accent SE, Standard Trans

General Information: DTC Detecting Condition

2014 Hyundai Accent SE, Standard TransSECTION DTC Detecting Condition
Item Detecting Condition Possible cause
Case1 DTC Strategy
  • Yaw rate & lateral G & longitudinal G sensor's message monitoring
  1. Faulty Yaw Rate & Lateral G & longitudinal G sensor
  2. Open or short of Yaw Rate & Lateral G & longitudinal G sensor
Enable Conditions
  • In case that Yaw rate & lateral G longitudinal G sensor's message was not received for more than 500ms within normal voltage condition.
    • The Monitoring starts after Power-Up.
Case2 DTC Strategy
  • Open, short monitoring
Enable Conditions
  • In case sensor CAN BUS off state continued for more than 100ms.
Fail Safe
  • Inhibit the ESC/DBC control and allow the ABS/EBD control.
  • The ESC/DBC warning lamp is activated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.