Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSIMMOBILIZER SYSTEM DIAGNOSISDTC P169A: IMMOBILIZER-SMARTRA AUTHENTICATION FAILGDS DIAGNOSTICSMONITOR GDS DATA
2014 Hyundai Accent SE, Standard Trans
Monitor GDS Data
2014 Hyundai Accent SE, Standard TransSECTION Monitor GDS Data
- Connect GDS to Data Link Connector (DLC).
- IGN "ON" & Engine "OFF".
- After connecting GDS, Monitor the "Current Data" to check "ECM, Key and Smartra Status".
Specification: 'LEARNT'
Courtesy of HYUNDAI MOTOR AMERICA
This data shows that 3 keys have been taught, ECU had been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.
- Has the "SMARTRA STATUS" been learnt?
YES
- Keep "KEY ON" status for 1 hours to withdraw "Locked by Timer" status. Then register transponder and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.