Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSIMMOBILIZER SYSTEM DIAGNOSISDTC P169A: IMMOBILIZER-SMARTRA AUTHENTICATION FAILCOMPONENT INSPECTION
2014 Hyundai Accent SE, Standard Trans
Component Inspection
2014 Hyundai Accent SE, Standard TransSECTION Component Inspection
- Check SMARTRA.
- IGN "ON" & Engine "OFF".
- Neutralize Both "SMARTRA" and "ECM" and Register transponder key by GDS.NOTE: Pin code is required to Neutralize SMARTRA and to Register transponder key
- Are Neutralizing and Registering completed normally?
YES
- Perform all the key teaching procedure with GDS. (All the keys must be retaught) and then, go to "VERIFICATION OF VEHICLE REPAIR " Procedure.
NO
- Substitute with a known-good SMARTRA and Perform Key teaching procedure.
- If the problem is corrected, replace SMARTRA and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.