SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 40 (ENGINE CONTROL SYSTEM (DTC TROUBLESHOOTING) (2 OF 4) - 3.8L)DTC P0140: O2 SENSOR CIRCUIT NO ACTIVITY DETECTED (BANK 1/SENSOR 2)DTC DETECTING CONDITION
2013 Hyundai Genesis Coupe 2.0T Premium

DTC P0140: O2 Sensor Circuit No Activity Detected (Bank 1/Sensor 2): DTC Detecting Condition

2013 Hyundai Genesis Coupe 2.0T PremiumSECTION DTC Detecting Condition
WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Monitor signal voltage
  • Poor connection
  • Open in harness
  • HO2S (B1/S2)
  • ECM
Enable Conditions
  • Battery voltage ≥ 10V
  • Engine running ≥ 60 sec
  • Engine warm-up state
  • No disable faults
Threshold value Case 1
  • 1.2V ≤ Voltage of HO2S ≤ 3.9V

    (at pumping current ON)
Case 2
  • 0.415V ≤ Voltage of HO2S ≤ 0.515V

    (at pumping current OFF)
Diagnosis Time
  • Continuous (more than 76.5 sec. failure for every 90 sec. test)
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.