DTC P0110: Intake Air Temperature Sensor 1 Circuit: DTC Detecting Condition

2013 Hyundai Genesis Coupe 2.0T PremiumSECTION DTC Detecting Condition
WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy Case 1
  • Start Test : Monitors the difference between max and min IAT in order to detect movement in IAT for a certain time.
  • Faulty IATS
Case 2
  • Drive test : Performs the max and min delta check while driving under load for a length of time followed by an idle for a certain time.
Enable Conditions
  • Engine soaked time > 360min
  • Engine Running State
  • No fault present
  • IAT stored previous trip
  • No IAT Tests pending
Threshold value
  • Max IAT - Min IAT ≀ 3Β°C (5.4 Β°F)
Diagnosis Time
  • Continuous (10 min.)
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.