Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERBUTTON ENGINE START SYSTEMPDM (POWER DISTRIBUTION MODULE)DTC B1603: CAN BUS OFFDTC DETECTING CONDITION

2013 Hyundai Genesis Coupe 2.0T Premium

DTC B1603: CAN Bus Off: DTC Detecting Condition

2013 Hyundai Genesis Coupe 2.0T PremiumSECTION DTC Detecting Condition

DTC DETECTING CONDITION CHART

Item	Detecting Condition	Possible Cause
DTC Strategy	CAN Communication Check	BCM, PDM are not Sleep condition CAN High and Low Line short to ground coincident CAN High and Low Line short to battery coincident
Enable Conditions	BCM, PDM power on
Threshold Value	CAN High/Low: 0V or B+
Diagnostic Time	Immediately
DTC Erasing Time	DTC is erased immediately after trouble fixed.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.