Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 22 (AUTOMATIC TRANSAXLE DIAGNOSIS - A6MF2)
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Section 22 (Automatic Transaxle Diagnosis - A6MF2)
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Section 22 (Automatic Transaxle Diagnosis - A6MF2)
WARNING: This page is about a different variant/trim than selected.
- DTC Index
- DTC P0601: Internal Control Module Memory Check Sum Error
- DTC P0705: Transmission Range Sensor Circuit Malfunction
- DTC P0706: Transmission Range Sensor Circuit Range/Performance
- DTC P0712: Transmission Fluid Temperature Sensor 'A' Circuit Low Input
- DTC P0713: Transmission Fluid Temperature Sensor 'A' Circuit High Input
- DTC P0717: Input Turbine Speed Sensor 'A' Circuit No Signal
- DTC P0722: Output Speed Sensor Circuit No Signal
- DTC P0731: Gear 1 Incorrect Ratio
- DTC P0732: Gear 2 Incorrect Ratio
- DTC P0733: Gear 3 Incorrect Ratio
- DTC P0734: Gear 4 Incorrect Ratio
- DTC P0735: Gear 5 Incorrect Ratio
- DTC P0729: Gear 6 Incorrect Ratio
- DTC P0741: Torque Converter Clutch Circuit Performance or Stuck Off
- DTC P0743: Torque Converter Clutch Circuit Electrical
- DTC P0748: Pressure Control Solenoid Valve (VFS) 'A' Electrical
- DTC P0753: Shift Control Solenoid Valve 'A' Electrical (UD/B)
- DTC P0758: Shift Control Solenoid Valve 'B' Electrical (2-6/B)
- DTC P0763: Shift Control Solenoid Valve 'C' Electrical (35R/C)
- DTC P0768: Shift Control Solenoid Valve 'D' Electrical (OD/C)
- DTC P0773: Shift Control Solenoid Valve 'E' Electrical (SS-A)
- DTC P0880: TCM Power Signal Error Open Short (GND)
- DTC P0955: Auto Shift Manual Mode Circuit
- DTC P2709: Shift Control Solenoid Valve 'F' Electrical (SS-B)
- DTC U0001: High Speed CAN Communication Bus Off
- DTC U0100: Lost Communication With ECM PCM 'A'
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.