Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 21 (ENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 2) - G2.4 DOHC)DTC P2626: O2 SENSOR PUMPING CURRENT TRIM CIRCUIT/OPEN (BANK 1 SENSOR 1)INSPECTION/REPAIRW/HARNESS INSPECTIONCONTROL CIRCUIT INSPECTION
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Control Circuit Inspection
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Control Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF".
- Disconnect HO2S connector.
- Ignition "ON", Engine "OFF".
- Measure voltage between VRC terminal of the sensor harness connector and chassis ground.
Specification : Approx. 2~3V
- Measure resistance between VRC terminal and other terminals of the HO2S harness connector.
Specification : Infinite
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.