General Information: DTC Detecting Condition

2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION

Item Detecting Condition Possible cause
DTC Strategy
  • Plausibility check during fuel cut-off phase
  • Poor connection or damaged harness
  • Front HO2S
Enable Conditions
  • Fuel cut-off
  • Wide range sensor pump current valid
  • Sensor heater controlled heating
  • Exhaust gas temp. > 300Β°C (572Β°F)
  • 10V < Battery voltage < 16V
Threshold value
  • Signal < 3.1V
Diagnosis Time
  • 6 sec. After fuel cut-off
MIL On Condition
  • 2 driving cycle
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.