SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 21 (ENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 2) - G2.4 DOHC)DTC P0661: INTAKE MANIFOLD TUNING VALVE CONTROL CIRCUIT LOW (BANK 1)INSPECTION/REPAIRCOMPONENT INSPECTION
2011 Hyundai Santa Fe GLS, 3.5 G, AWD

Component Inspection

2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Component Inspection
WARNING: This page is about a different variant/trim than selected.
  1. IG KEY OFF.
  2. Disconnect VIS Sol. Valve harness connector.
  3. Measure resistance between power terminal and control terminal of VIS Sol. Valve connector. (Component side)

    Specification 

    TEMPERATURE AND RESISTANCE REFERENCE CHART

    Temp. VIS Sol. Valve resist
    22°C (72°F) 30 ~ 35Ω
    Fig 1: Measuring Resistance Between Power Terminal And Control Terminal Of VIS Sol Valve Connector (Component Side)
    G06841360Courtesy of HYUNDAI MOTOR CO.
  4. Is resistance within specification?

    YES 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known-good component and check for proper operation. If the problem is corrected, replace component and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.