Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (3 OF 3) - G3.5 DOHCDTC P0647: A/C CLUTCH RELAY CONTROL CIRCUIT HIGHGENERAL INFORMATIONDTC DETECTING CONDITION

2011 Hyundai Santa Fe GLS, 3.5 G, AWD

General Information: DTC Detecting Condition

2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION DTC Detecting Condition

DTC DETECTING CONDITIONS

Item	Detecting Condition	Possible cause
DTC Strategy	Detects circuit short to low voltage	Poor connection Short to power in A/C relay circuit Faulty A/C relay Faulty PCM
Enable Conditions	After 0.5 sec under conditions below No DTC exists Engine works 11V ≤ Battery voltage ≤ 16V
Threshold value	Short to power
Diagnosis Time	Continuous (More than 5 seconds failure for every 10 seconds test)
MIL On Condition	DTC only (NO MIL ON)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.