SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011GENESIS 3.8REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (G6DB/G6DA - GSL 3.3L/3.8L) (1 OF 3)DTC P0113: INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH INPUTDTC DETECTING CONDITION
2011 Hyundai Genesis 3.8

DTC P0113: Intake Air Temperature Sensor 1 Circuit High Input: DTC Detecting Condition

2011 Hyundai Genesis 3.8SECTION DTC Detecting Condition
DTC P0113 DETECTING CONDITION TABLE

Item Detecting Condition Possible Cause
DTC Strategy
  • This code detects a continuous short to high in either the signal circuit or the sensor
  • Connecting condition
  • Open or short to battery in harness
  • Open in ground harness
  • IATS
  • ECM
Enable Conditions
  • Engine running state
  • No Vehicle speed sensor fault
  • No ECTS fault
  • No MAFS fault
  • Intake airflow < 15 g/s
  • Vehicle speed < 25kph (9.3mph)
  • Engine coolant temperature > 50°C (122°F)
Threshold value
  • Intake air temperature sensor's voltage > 4.9V
Diagnosis Time
  • Continuous (More than 10 seconds failure for every 20 seconds test)
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.