Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009TUCSON LIMITED, 2.0 BREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDTC TROUBLESHOOTING PROCEDURES (2.0L)TROUBLESHOOTING FOR DTCP0505 IDLE AIR CONTROL SYSTEMCOMPONENT INSPECTION
2009 Hyundai Tucson Limited, 2.0 B
Component Inspection
2009 Hyundai Tucson Limited, 2.0 BSECTION Component Inspection
- Ignition "OFF"
- Remove ICA from Throttle body and Check for throttle bore, throttle plate and the ICA passages for chocking and for any foreign objects. Repair or clean as necessary.
- Ignition "ON" & Engine "OFF".
- Connect scan tool and select "IDLE SPEED ACTUATOR" parameter on the "ACTUATION TEST" mode.
- Activates ICA by pressing "STAT" key
- Check the ICA for clicking sound and visually verifying valve closes and opensNOTE: Repeat numerous times to ensure valve reliability
- Is ICA OK?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
NO
- Check ICA valve for contamination, deterioration, or damage. Substitute with a known-good ICA valve and check for proper operation. If the problem is corrected, replace ICA valve and then go to "VERIFICATION OF VEHICLE REPAIR " procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.