Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
2009 Hyundai Entourage LimitedSECTION Component Inspection
- Check TPS
- IG "OFF" and disconnect TPS connector.
- Measure resistance between terminals 4 and 5 of TPS connector (component side).
Specification: 4 ~ 6 kΩ
- Is the measured resistance within specification?
YES
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good ECT motor & TPS and check for proper operation. If the problem is corrected, replace ECT motor & TPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
CAUTION: Procedure of ETS Initialization- Erase the trouble codes on PCM
- Turn the ignition key off and keep this condition until the main relay is turned off. (It will takes 10sec.)
- Turn ignition key on more than 1 second to record the throttle motor position on the EEPROM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.