Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2009ENTOURAGE LIMITEDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTC TROUBLESHOOTING PROCEDURES (1 OF 2)DTC P0102 MASS OR VOLUME AIR FLOW CIRCUIT LOW INPUTDTC DETECTING CONDITION

2009 Hyundai Entourage Limited

DTC P0102 Mass Or Volume Air Flow Circuit Low Input: DTC Detecting Condition

2009 Hyundai Entourage LimitedSECTION DTC Detecting Condition

DTC DETECTING CONDITION CHART

Item	Detecting Condition	Possible cause
DTC Strategy	Compares the airmeter input frequency to a low limit	Poor Connection Open or short in harness MAFS PCM
Enable Conditions	Engine Speed ≥ 500 RPM Engine Running Time ≥ 5 second Ignition Voltage ≥ 11V
Threshold value	MAF frequency signal < 1000Hz
Diagnosis Time	Continuous (More than 75 second failure for every 125 second tests)
MIL On Condition	2 Driving Cycles

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.