Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Automatic Transaxle Shift Control: Installation: Notes
2003 Hyundai Accent BaseSECTION Notes
WARNING: This page is about a different variant/trim than selected.
- Apply a coating of the specified grease to the interior of the bushing.
Specified grease: Chassis grease SAE J310, NLGI No.0
- Move the shift lever and the transaxle range switch to the N position, and install the control cable.
- When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.