Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1999ELANTRA WAGON L4-2.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSBY SYMPTOMRECALLSRECALL 00V259001: POSSIBLE ENGINE STALLING
1999 Hyundai Elantra Wagon L4-2.0L
Recall 00V259001: Possible Engine Stalling
1999 Hyundai Elantra Wagon L4-2.0LSECTION Recall 00V259001: Possible Engine Stalling
Some Sonata vehicles equipped with 2.5 liter V-6 engines and all Elantra model vehicles may have experienced intermittent low-speed engine stalling, which could occur if the MAF (Mass Air Flow) Sensor electrical signal is interrupted as a result of engine vibration transmitted to the MAF Sensor connector wiring harness.
This condition can cause the engine to stall, increasing the risk of a crash.
Dealers will re-route the MAF Sensor connector wiring harness.
Owner notification is expected to begin during October 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Hyundai at 1-800-633-5151. Also contact the National Highway Traffic Safety Administration's Auto Safety Hotline at 1-888-DASH-2-DOT (1-888-327-4236).
This condition can cause the engine to stall, increasing the risk of a crash.
Dealers will re-route the MAF Sensor connector wiring harness.
Owner notification is expected to begin during October 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Hyundai at 1-800-633-5151. Also contact the National Highway Traffic Safety Administration's Auto Safety Hotline at 1-888-DASH-2-DOT (1-888-327-4236).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.