Moonroof Motor Test

2009 Honda Odyssey EX-LSECTION Moonroof Motor Test
  1. Remove the headliner (see HEADLINER REMOVAL/INSTALLATION ).
  2. Disconnect the 6P connector (A) from the moonroof motor/limit switch (B).
    Fig 1: Identifying 6P Connector And Moonroof Motor/Limit Switch
    G05526785Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check the motor by connecting power and ground according to Fig 2.
    Fig 2: Connecting Power And Ground
    G05526786Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the motor does not run, replace it.
    NOTE: See closing force check (see CLOSING FORCE AND OPENING DRAG CHECK ) for motor clutch test.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.