Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 2610: DRAM Diag
- Check the vehicle battery condition first (see BATTERY TEST ).
- This DTC sets when a problem with the audio-navigation unit internal DRAM is detected.
- Before you troubleshoot, make sure to follow the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION -('10 MODEL) ).
- Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Go into the Diagnostic Menu, and select the Self-Diagnosis Mode in the Select Diagnosis items menu (see SYSTEM DIAGNOSTIC MODE - ('10 MODEL) ).
- Select the System Links, then select the ECU Info.
Is D-RAM OK indicated?
YES -Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION - ('10 MODEL) ).
NO -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION - ('10 MODEL) ).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.