SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 75 (NAVIGATION SYSTEM)DTC TROUBLESHOOTINGDTC 1303: GPS RECEIVER ERROR 2
2009 Honda CR-V EX, 2.4 RE3

DTC 1303: GPS Receiver Error 2

2009 Honda CR-V EX, 2.4 RE3SECTION DTC 1303: GPS Receiver Error 2
WARNING: This page is about a different car, the 2011 Honda CR-V and 2010 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Check the vehicle battery condition first (see BATTERY TEST ).
  • This code sets when there is an internal GPS receiver problem.
  • Before you troubleshoot, make sure to follow the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION -('10 MODEL) ).
  • Make sure the vehicle is parked outside, away from buildings.
  • Aftermarket metallic window tint or electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
  1. Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
  2. Turn the ignition switch to LOCK (0) and then back to ON (II).
  3. Check for the hard error code (see HOW DO I FIND THE LOCAL ADDRESS OF A BUSINESS THAT IS PART OF A NATIONAL CHAIN (FOR EXAMPLE, STARBUCKS)? ).

    Is DTC 1303 indicated? 

    YES  -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION - ('10 MODEL) ).

    NO  -Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION - ('10 MODEL) ).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.