Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 73 (ENGINE COOLING SYSTEM)
2009 GMC Canyon 4D Pickup, 2.9 9
Section 73 (Engine Cooling System)
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Section 73 (Engine Cooling System)
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Diagnostic Information and Procedures
- Repair Instructions
- Cooling System Draining and Filling (Static Fill)
- Cooling System Draining and Filling (Vac N Fill)
- Flushing
- Radiator Cleaning
- Coolant Recovery Reservoir Replacement
- Radiator Inlet Hose Replacement (2.9L, 3.7L)
- Radiator Outlet Hose Replacement (2.9L, 3.7L)
- Radiator Vent Inlet Hose Replacement
- Fan Replacement (2.9L, 3.7L)
- Fan Clutch Replacement
- Engine Coolant Thermostat Replacement (With 2.9L and 3.7L)
- Water Outlet Housing Replacement (With 2.9L and 3.7L)
- Water Pump Replacement (2.9L,3.7L)
- Fan Shroud Replacement (2.9L, 3.7L)
- Radiator Replacement
- Coolant Heater Replacement (2.9L,3.7L)
- Coolant Heater Cord Replacement (2.9L,3.7L)
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.