Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Anti-Lock Brake System
- Diagnostic System Check - ABS
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) Identification
- DTC C0221: RF Wheel Speed Sensor Circuit Open; C0222: RF Wheel Speed Signal Missing; C0223: RF Wheel Speed Signal Erratic; C0225: LF Wheel Speed Sensor Circuit Open; C0226: LF Wheel Speed Signal Missing; C0227: LF Wheel Speed Signal Erratic
- DTC C0229: Drop Out Of Front Wheel Speed Signals
- DTC C0235: Rear Wheel Speed Signal Circuit Open; C0236: Rear Wheel Speed Signal Circuit Missing; C0237: Rear Wheel Speed Signal Erratic; P1504: Vehicle Speed Output Circuit
- DTC C0238: Wheel Speed Mismatch
- DTC C0241: EBCM Control Valve Circuit; C0245: Wheel Speed Sensor Frequency Error; C0254: EBCM Control Valve Circuit
- DTC C0265 or C0266: EBCM Relay Circuit
- DTC C0267: Pump Motor Circuit Open/Shorted; C0268: Pump Motor Circuit Open/Shorted
- DTC C0269 or C0274: Excessive Dump/Isolation Time
- DTC C0271, C0272 or C0273: EBCM Malfunction
- DTC C0281: Brake Switch Circuit
- DTC C0286: ABS Indicator Lamp Circuit Shorted to B+
- DTC C0288: Brake Warning Lamp Circuit Shorted to B+
- Symptoms - Anti-Lock Brake System
- ABS Indicator Always On
- ABS Indicator Inoperative
- Repair Instructions
- Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
