Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Important: Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
- Install EBCM (2) on to the BPMV (3).
- Connect the electrical connectors to the EBCM.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the 4 new T-25 Torx® screws (1) in the EBCM (2).
Tighten
Tighten the 4 T-25 Torx® screws to 5 N.m (39 lb in) in an X-pattern.
- Revise the tire calibration using the Scan Tool.
- Return to Diagnostic System Check - ABS .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
