Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2022TRANSIT CONNECT TITANIUM, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 761 (ENGINE CONTROLS - PINPOINT TESTS (DIESEL) - FAULT CODE INDEX, PINPOINT TESTS A - AN)PINPOINT TESTS AJ: POWERTRAIN CONTROL MODULE (PCM) POWER RELAYINTRODUCTION
2022 Ford Transit Connect Titanium, Gas
Pinpoint Tests AJ: Powertrain Control Module (Pcm) Power Relay: Introduction
2022 Ford Transit Connect Titanium, GasSECTION Introduction
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.
This pinpoint test is intended to diagnose the following:
Harness Side
| Circuit | Pin |
|---|---|
| PCMRC (PCM Relay Control) | 50 |
| ISP-R (Ignition Switch Position Run) | 21 |
| VPWR (Vehicle Power) | 17 |
| VPWR (Vehicle Power) | 16 |
| VPWR (Vehicle Power) | 2 |
| VPWR (Vehicle Power) | 1 |
| PWRGND (Power Ground) | 47 |
| PWRGND (Power Ground) | 61 |
| PWRGND (Power Ground) | 62 |
| PWRGND (Power Ground) | 76 |
| PWRGND (Power Ground) | 77 |
Harness Side
| Circuit | Pin |
|---|---|
| PCMRC (PCM Relay Control) | 39 |
| VPWR (Vehicle Power) | 51 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.