Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2022TRANSIT CONNECT TITANIUM, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 761 (ENGINE CONTROLS - PINPOINT TESTS (DIESEL) - FAULT CODE INDEX, PINPOINT TESTS A - AN)
2022 Ford Transit Connect Titanium, Gas
Section 761 (Engine Controls - Pinpoint Tests (Diesel) - Fault Code Index, Pinpoint Tests A - An)
2022 Ford Transit Connect Titanium, GasSECTION Section 761 (Engine Controls - Pinpoint Tests (Diesel) - Fault Code Index, Pinpoint Tests A - An)
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Fault Code Index
- Pinpoint Tests A: No Start
- Pinpoint Tests Aa: Auto Start Stop
- Pinpoint Tests Ab: Engine Oil Level Overfull
- Pinpoint Tests AE: Unable To Activate Self Test/Network Communication Error
- Pinpoint Tests AF: Glow Plug System
- Pinpoint Tests Ag: Accelerator Pedal Position (App) Sensor
- Pinpoint Tests Ah: Cooling Fan
- Pinpoint Tests AJ: Powertrain Control Module (Pcm) Power Relay
- Pinpoint Tests AK: Turbocharger Actuator
- Pinpoint Tests An: Power Take Off (PTO) Control
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.