Symptom Chart(s)

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Symptom Chart(s)
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

Condition Action
A module does not communicate with the diagnostic scan tool GO to Pinpoint Test BO 
The lane keeping aid or lane keeping alert does not turn on or activate GO to Pinpoint Test A 
The lane keeping aid or lane keeping alert does not provide driver feedback once activated GO to Pinpoint Test B 
The display lines in the IPC do not turn green after the Lane Keeping System is turned on GO to Pinpoint Test BP 
The lane keeping aid or lane keeping alert provides early feedback on one side of the lane and late feedback on the other side of the lane GO to Pinpoint Test BQ 
Degraded performance from the lane keeping aid or lane keeping alert system GO to Pinpoint Test BQ 
LANE KEEPING SYSTEM MALFUNCTION - SERVICE REQUIRED message in the IPC GO to Pinpoint Test BR 
IPMA CAMERA TEMPORARILY NOT AVAILABLE message in the IPC GO to Pinpoint Test BS 
IPMA CAMERA LOW VISIBILITY - CLEAN SCREEN message in the IPC GO to Pinpoint Test BT 
IPMA CAMERA MALFUNCTION - SERVICE REQUIRED message in the IPC GO to Pinpoint Test D 
The lane keeping aid and lane keeping alert will not turn off GO to Pinpoint Test BU 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.